Page
34
of
54
headset registered to the base, it will send the command further to the headset and reset all user settings
for the headset as well.
9.4.8
Factory Reset
Allows the user to perform factory reset and return the base to its initial state and clear the cache
memory. If there is a headset registered to the base it will send the command further to the headset and
perform factory reset for it too.
Fig.24 Factory Reset
9.5
Call activity on base
To have call activity on the base, a master headset must be registered and locked to the base. If the master
headset loses connection during call activity, all the calls will be put on hold until connection is restored. If
the link fails to restore in a couple of seconds, all calls will be terminated.
9.6
Incoming call
The base will notify the user with visible and audible indication whether an incoming call is from EHS or
USB line (
Fig.25)
. If both lines are in idle state and an incoming call is received to one of the lines, the base
rings and displays the call. However, if there are two simultaneous incoming calls from two different lines,
the active control is made by the first incoming call (the first that came is served first). The second incoming
call cannot be accepted by the base until the first incoming call has been answered or ended, or the line is
swapped manually by the user. This means that in case of having one of the lines occupied (in active call),
the new incoming call will be displayed as waiting in a queue.
Fig.25 Incoming call
NOTE:
Reset user settings returns all configurations to
their initial state. That is also what happens when we
perform Factory reset, but Factory reset will delete all
current registrations as well.
