OPENING YOUR SAFE FOR THE FIRST TIME
Upon irst opening, users should open the safe with the emergency key. The operation
in details refers to “opening the safe with the emergency key”.
● Remove emergency lock cover, then insert the emergency key, and turn it count
clockwise.
● Turn the knob (master key) clockwise to open the door.
CAUTION: Finish operation, pull out the emergency key and keep it in a safe
place.
● Turn the knob (master key) counter clockwise to close the door.
CLOSING DOOR
OPENING DOOR
● Press “START” button, and the LED display will show “----”
● Input your user code (6 digits), The code lock will be unlocked with the green light
on the key pad.
● Turn the knob (master key) clockwise and open the door.
CAUTION: The user preset code “123456”.The code lock has the function of
auto-locking, and if there is not any operation after inputting the code, the lock will
lock automatically again. If inputting wrong code for three times, the lock will lock
automatically for 3 minutes.
● With the door open, press “START” button, the LED display will show “----”.
● Input your new user code(6 digits), and press the “RESET” button to conirm.
● The display will show “USER-IN” to indicate the code setting is successful. So now
you can use your safe box by new code.
● With the door open, press the “RESET” button, the LED display will show “----”.
● Then press the “START” button, and “----”on the LED display will stop lashing,
which indicate the lock has enter into the state of code setting.
● Input any 6 digits code, LED display will show “SUPER-IN”
● The display will show “SUPER-IN” to indicate the master code setting is successful.
So now you can use your safe box by new code.
SETTING THE USER CODE
SETTING THE MASTER CODE
INSERTING THE BATTERIES
● Open the door.
● Insert 4AA batteries into the battery compartment.
● Under normal condition, if the LED display shows “LO-BAT”, you should change the
batteries after entering “START” button.
CAUTION: Replace 4 fresh batteries by lining them up in a manner as indicated by
the “+“ and “ - ” signs. When outage for thirty minutes or longer, you should reset the
user code.
OPENING THE SAFE IN EMERGENCY
Upon first receipt of the safe, or either the electronic circuit malfunction or codes
unknown. You could also use the emergency key to open the safe.
● Remove the cover of the emergency lock.
● Insert the emergency key to the key hole, turn count clockwise then turn the knob
,
(master key) clockwise to open the door.
