UniBox-
3210 User’s Manual
http://www.unitedlink.com.tw
11
2.3.2
Installing a SO-DIMM
1. Align a SO-DIMM on the slot such that the notch on the SO-DIMM matches the break on
the slot.
2. Firmly insert the SO-DIMM into the slot until the retaining clips at both ends fully snap
back in place and the SO-DIMM is properly seated.
A DDR3 SO-DIMM is keyed with a notch so that it fits in only one
direction. DO NOT force a SO-DIMM into a socket to avoid
damaging the SO-DIMM.
The DDR3 SO-DIMM sockets do not support DDR/DDR2
SO-DIMMs. DO NOT install DDR/DDR2 SO-DIMMs to the DDR3
SO-DIMM socket.
The SO-
DIMM only it’s in one correct orientation. It will cause
permanent damage to the motherboard and the SO-DIMM if you
force the SO-DIMM into the slot at incorrect orientation.
Make sure to unplug the power supply before adding or removing
SO-DIMMs or other system components. Failure to do so may cause
severe damage to both the motherboard and the components.
