34
BAMOBIL D3.2
Rotor position encoder - connection via a bl-tacho
only for BAMOBIL-D3-xx-bl
3 rotor position encoder
signals (Hall sensors) for the
commutation; with or
without a brushless tacho.
The rotor position encoder is
galvanically connected with
the device zero (GND).
The voltage of 15V is
supplied by the servo-drive.
Provide an adapter in case
the tacho voltage at rated
speed is superior to 10V~.
For lower tacho voltages
connect X7: pin 1, 9, and 11.
Connect the tacho center
point to X7:1.
U
se only motors with rotor
position encoders (bl) which have been approved by UNITEK (Appendix A).
Observe the motor specific connection data sheet (bl)!
Connector X7
15-pole D-connector
Connecting cable
12 signal conductors, supply lines, temp., min. Cross-section
0.25mm
For link chains use appropriate cables!
Cable length
for >25m the cross-section of the cable used must be
increased by one grade
Shield connection
across connector X7 -
connect the shield
to the connector housing
across the motor connector - connect the shield to the
connector housing
Setting parameter
see software Manual DS NDrive
Connect.assignmen
Soldered side
M, pin