A1 PRO User Manual
Copyright © 2020 Unitree Robotics. All Rights Reserved
7
Unpacking
Place the box on the flat ground according to the placement requirements (Face up), then open the
upper box and lift the whole robot out, as shown in the figure above. Remove the robot and remote
control, charger, etc. from the box, place the robot on the flat ground, untie the velcro strap of the
robot's leg, and then prepare for the boot.
Before Packing
First rotate the legs of the robot to the position shown in Figure [4] above(the rear leg is folded up:
rotate the rear leg hip motor so that the rear thigh is placed in the position shown in the above figure [4]
above, and the lower leg is closed. Place it in the position shown in Figure [4] above, and tie the left rear
leg and the right rear leg together with a Velcro strap, as shown in Figure [3] above. The front leg is
folded up: similar to the hind leg, as shown above Figure [3], [4] above placed and bundled).
Packing
After completing the preparation work before packing, load the robot into the lower case [2] in the
direction shown in the figure (note that the two rear thighs of the robot are respectively engaged in the
A and B slots during the loading process. After the robot is loaded into the lower case, place the remote
control, charger, etc. that came with the product into the corresponding positions in the upper case and
fix them with elastic straps, make sure the above parts do not fall when the upper case is closed.
Part Name of the Remote Control
[1]
[2]
[1] Joystick
[2] Mobile phone
[3] Rocker (pull out the
telescopic rod when using,
take it out, and put it back
when it is transport or not
used for a long time )
If not using the robot for a long time, take out the battery pack and put it into battery box.
、
[3]
