GEMSCOPE
UNITRON
®
73 Mall Drive, Commack, NY 11725 • 631-543-2000 • www.unitronusa.com
8
DETAILED ASSEMBLY
(continued)
Installing the Fluorescent
Overhead Light (Fig. 3)
Connect the overhead fluorescent light to the front
of the stage by lining up the male and female holes
on the snap connector
.
Once connected, slide the securing threaded
connector into place. Hand-tighten the connector
.
If possible, it is recommended to further tighten the
connector by using rubber tipped pliers. This will
ensure that the gooseneck will not loosen and rotate
as the overhead fluorescent light is being used.
Installing the Optional LED Light (Fig. 3A)
Remove the plastic cap covering the opening to the
LED socket. Insert the LED light guide into the
socket and seat it as deeply as possible.
The LED light may be varied in intensity by adjusting
the intensity dial labeled
“Reflected” on the side of
the Gemstand.
Fig. 3A
Fig. 3
