8700
–
8701 TITANIUM
11
3.2
Define the settings for each of the tuners (INPUT > TUNER)
o
Input Selection
: this refers to the LNB inputs; make sure the
transponder frequencies you choose correspond to the right polarity of
the LNB inputs
o
Frequency (Mhz):
choose the frequency of the transponder you want to
receive
o
Baud Rate (kBd):
choose the baud rate of the transponder signal you
want to receive
o
Modulation:
choose between DVB-S and DVB-S2
o
Enable:
click the tick box to enable the tuner (this is disabled by
default)
o
Check the lock status, signal level, signal quality and signal to Noise to
see if the tuner locks on the selected transponder
o
Press
APPLY
to confirm the parameters.
o
The module will now set the tuner to this frequency. Wait until the
correct parameters are loaded. When the tuner is able to lock on
the frequency, the services list from this transponder will be
shown.
o
Services list:
after a tuner is locked, the services will appear. A RED lock
indicates that the service is scrambled, a GREEN lock indicates that the
service is clear
o
Network parameters:
this is an overview of the following
information: Name, ONID, TSID, NID and version
