23
22
Using cordless phones (DECT) or older phones
with headset profile only
If your phone only supports the headset
profile (HSP), the connection must be initiated
manually for outgoing calls. This often applies to
cordless home phones (DECT standard).
For these phones, the audio indicator might not
blink blue even if the phone is paired.
1. Dial the number you want to dial on your
phone, or select it from the phone book.
2. Briefly press the connect (
) button, then
wait 5 seconds.
3. The dialing process will automatically start
and the audio indicator will turn solid blue.
You may hear a confirmation beep through
your hearing aids.
Ending a call
To end a phone call via your uDirect
2
, briefly
press the access ( ) button. The call will
terminate and your hearing aids will return to
Speak into the uDirect
2
, not into the phone,
when the call is in progress.
For your safety, the hearing aid microphones will
remain on at reduced levels during phone calls
and audio streaming.
Only one phone call at a time is possible. A
second ringing phone is ignored while another
call is already connected.
Making phone calls
Make sure the uDirect
2
and
your phone are connected
through Bluetooth as
described on page 51.
Use the phone keypad to
enter the number and press
the phone dialing button.
When connected, you will hear the dialing tone
through your hearing aids after approximately
3 seconds.
