Unitronics
1
Jazz
™PLC+HMI
Micro-PLC+HMI Installation Guide
JZ20-R10/JZ20-J-R10
JZ20-R16/JZ20-J-R16
JZ20-J-R16HS
6 Digital Inputs including 2 HSC, 4 Relay Outputs
6 Digital Inputs including 2 HSC, 2 Analog/Digital Inputs,
2 Analog Inputs, 6 Relay Outputs
6 Digital Inputs including 3 HSC/Shaft-encoder,
2 Analog/Digital Inputs, 2 Analog Inputs, 6 Relay Outputs
Before using this product, the user must read and understand this document.
For additional information regarding this product, refer to the user guide and technical specifications.
All examples and diagrams are intended to aid understanding, and do not guarantee operation.
Unitronics accepts no responsibility for actual use of this product based on these examples.
Please dispose of this product according to local and national standards and regulations.
Only qualified service personnel should open this device or carry out repairs.
Failure to comply with appropriate safety guidelines can cause severe injury or property damage.
Do not attempt to use this device with parameters that exceed permissible levels.
To avoid damaging the system, do not connect/disconnect the device when power is on.
Environmental Considerations
Do not install in areas with: excessive or conductive dust, corrosive or flammable gas,
moisture or rain, excessive heat, regular impact shocks or excessive vibration.
Ventilation: 10mm space required between the PLC+HMI
s’ top/bottom edges & enclosure
walls.
Do not place in water or let water leak onto the unit.
Do not allow debris to fall inside the unit during installation.
Mounting
Dimensions
* Note that for JZ20-J modules those dimensions are 7.5 mm (0.295
”).
