UNITY Lasers s.r.o.
Elite Pro series Operational Manual
(Revision 2022-10)
16
Front & Rear panel view (Elite 5 PRO)
NO.
Name
Function
1.
Laser Aperture
Laser output, do not look directly into this aperture.
2.
Aperture masking
plate
Can be moved up and down when two locking bolts are loosened.
3.
Laser emission
When this indicator is lit up the laser system is ready to emit the
laser radiation as soon as it receives instructions from control
software.
4.
3-Pin Interlock
Laser output is available only when the interlock is connected.
It could be used to connect a laser emergency switch.
5.
Key switch
Turn the key switch ON to allow laser output.
7.
Power in & out
AC100-240V power input and output sockets. With output
feature you can connect the device to one another using the
input and output sockets. They must be the same fixtures. DO
NOT mix fixtures.
6.
Fuse
Current rating 3.15A, slow acting type.
10.
ILDA OUT
ILDA compatible output port with signals from the projector’s
FB4 controller.
11.
Safety eyelet
Use this together with appropriate safety wire to secure the
system against unexpected fall.
9.
FB4 laser
control interface
The inbuilt control interface allows you to control the laser
via Ethernet and DMX/ArtNet, but it also handles all the basic
settings of the laser system (master size and position, method
of control, colour settings etc.). All of these settings can be
accessed through the menu using the endless rotary knob and
once saved they are stored on included mini SD card.
8.
Use these ports to connect DMX control signal or to daisy chain
the DMX signal between multiple laser display systems.
DMX
Input/Though
1
10
2
3
9
6
7
4
5
8
12
11
12.
Ethernet
Use this to control laser system by PC.
