3
Open oven door fully –strike match put it in ignition porthole in front of oven base. Press oven control knob
in and turn to No. 8 (high position). The burner will the ignite after a few seconds.
After ignition of the burner close the door gently and turn the control to the temperature required using the
guide printed on the oven door glass, or use the book temperature chart as a guide.
IMPORTANT: DO NOT leave oven control in open position while looking for matches and then light oven as
this can cause an explosion.
As your stove works on liquid petroleum gas the cylinders must installed outside and be protected against
the weather.
When required setting has been reached oven flame will lower its level, thus indicating that oven is now
ready for use. (Only for models G014 & G114).
The thermostat will maintain the heat constant in the oven. (Only for models G014 & G114).
IMPORTANT: Always close oven door with moderate care to avoid extinguishing flame. If the model you
have purchased is not fitted with the thermostat the oven temperature can be controlled with the
thermostat in the door glass. (If fitted)
A spacious well balanced utility and storage drawer is provided.
Frequent use of warm soapy water is the best treatment for all parts of your cooker. Harsh abrasives will
spoil the glossy vitreous enameled surfaces and should definitely not be used. Lift burner tops and brush
parts thoroughly with a stiff brush. Always shake the burners after cleaning to ensure that no moisture
remains inside them as this will affect the burner.
It is strongly recommended that installation of the Univa Gas cooker be carried out by an experienced gas
fitter.
On the bottle gas model flexible rubber or plastic hose can be used but make sure that they are the correct
diameter and not perished or leaking.
Test all connections for leaks by applying thick soapy solution to all joints. Should any leaks occur bubbles
will form around the joints.
D-
UTILITY DRAWER
E-
CARE OF YOUR GAS COOKER
F-
INSTALLATION AND TESTING INSTRUCTIONS
