7
Anti-Tilt mechanism (Stabilizing bracket) – For 500mm range stoves only
Safety regulations stipulate that the Anti-Tilt mechanism supplied with the stove, must be
installed as shown.
IMPORTANT
: The instructions below are only relevant to the 500mm-range stoves.
“A” 1 x Anti-Tilt chain.
“B” 1 x Anti-Tilt hook with anchor sleeve.
“A” is factory fi
tted at the rear of the stove.
Position the stove and move “A” to touch the wall behind the stove.
Mark the hole where “A” touches the wall behind the stove.
Move the stove away from the wall to allow for an area to work in.
Using a 6.0 mm concrete drill bit, drill a hole at the marked position.
Using the stability hook and anchor sleeve
“B”, firmly secure “B” to the
wall.
Slide the stove back in the position and engage the stability chain “A” onto the stability
hook “B”.
The stove is secured and will not accidentally tilt if downward pressure is applied to
the open oven door.