Installation
The metal casing of this appliance has been coated with a preservative to protect it during
transport and storage. This should be removed during installation by using a non-abrasive
stainless-steel cleaner. Always follow the instructions given with the cleaner being used.
RISK! Ensure the appliance is not connected to power supply during this cleaning process.
When correctly installed, your product meets all safety requirements laid down for this
type of product. However, special care should be taken around the rear of the appliance
as these areas are not designed nor intended to be touched and may contain sharp or
rough edges that could cause injury. Always wear adequate Personal Protective
Equipment (PPE).
Note:
•
Two people are required to install the chimney hood
•
The fixings supplied are suitable for most installations. It is the responsibility of the installer to
ensure that the fixings are suitable for the ceiling type in the property
•
Cover any hob or surface below the area in which the extractor is to be installed, to avoid
any damage to it
6
