EN-58
Original User Guide | Pedelec Shimano Steps E8000 Version 1
9.5
Gear changes
Description
Cause
Remedy
No gear is displayed.
The gear is only displayed when the electronic gear shift is in use. Check whether the power supply cable is disconnected. If you are unsure, contact your
dealer.
When using an electronic gear
shift, pedal assistance seems to
be weaker when changing gears.
The pedal assistance is set to an optimum level by the computer.
This is not an error.
A noise can be heard after
changing gear.
Please contact your cycle dealer.
A noise can be heard from the
rear wheel during normal riding.
Gear changing is not set correctly.
a) Mechanical gear shift: Adjust the tensioning of the gear shift cable.
b) Gear shifting: Please contact your cycle dealer.
When you bring the bicycle to a
stop, the gear does not move to
the Start mode position.
Excessive pressure is being applied on the pedals.
Only apply gentle pressure to the pedals when changing gear.
The front or rear lights do not
light, even when the button is
pressed.
E-TUBE PROJECT may be set incorrectly.
Please contact your cycle dealer.
