UAD Powered Plug-Ins Manual
- 109 -
Chapter 9: UAD Delay Compensation
• Compensating for upsampled UAD plug-ins is not required when these plug-
ins are used for program material on the output bus, where latency is not a
consideration.
• If only one latency value is shown in
Table 7 on page 110
, the value ap-
plies to both UAD–1 and UAD-2. N/A means that sample rate is not sup-
ported.
• UAD Pultec-Pro only requires one compensation per instance. For example,
if using both MEQ-5 and EQP-1A within a single Pultec-Pro, only one in-
stance compensation is required.
• Since the maximum Samples value in one DelayComp instance is 128,
more than one DelayComp instance will be required (in series) if the com-
pensation value from
Table 7 on page 110
exceeds 128.
• Latency compensation techniques for upsampled plug-ins apply to UAD
Track Advance (
page 113
) as well.
• The latency in
Table 7 on page 110
is also produced when LiveTrack mode
(
page 89
) is used with upsampled plug-ins.
• Upsampled plug-in latency cannot be displayed in the
“Plug-In Latency Sec-
tion” on page 66
due to technical limitations.
