UAD Powered Plug-Ins Manual
- 474 -
Chapter 46: Precision Multiband
Power Switch
The Power Switch determines whether the plug-in is active. Click the toggle
button or the UA logo to change the state.
When the Power switch is in the Off position, plug-in processing is disabled
and UAD DSP usage is reduced (unless
“UAD-2 DSP LoadLock” on page 74
is enabled).
When the plug-in is bypassed with this switch (but not by the host bypass), the
I/O meters and the Input Level knob remain active.
Precision Multiband Latency
The Precision Multiband requires a large processing buffer to perform its
sonic wonders. This buffer results in a significantly larger latency than other
UAD plug-ins, including all other upsampled plug-ins. You may use Delay-
Comp or TrackAdv to compensate. See
“Compensating Upsampled Plug-Ins”
on page 108
for more information.
Important:
Compensating for Precision Multiband latency is not required if
the host application supports full plug-in delay compensation throughout the
entire signal path, or when it is used only on the outputs. See
“Host PDC Im-
plementation” on page 101
.
