PROGRAMMING TV/VCR COMBO CONTROL
If you own a TV/VCR Combo, perform the following
instructions to control this device:
1.
Turn on your TV/VCR Combo and insert a
video cassette.
2.
On the remote control, press
VCR
once.
Press and hold
SETUP
until the
VCR
key
blinks twice, then release
SETUP
.
3.
Use the
Setup Codes For TV/VCR Combos
(on
page 47) to locate the brand name and then
enter the first four-digit code for your TV/VCR
Combo. If you perform this procedure
correctly, the
VCR
key will blink twice.
NOTE: If the
VCR
key did not blink twice after
entering the code’s last digit, then repeat steps 2
through 3 and try entering the same code again.
If you’ve located a TV/VCR setup code that
works your TV/VCR Combo and a separate
TV code is also listed, you’ll need to program
this code into the remote control to access
volume control (see
Programming Device
Control
on page 8).
4.
Aim the remote control at your TV/VCR
Combo and press
POWER
once. The device
should turn off. If it does not respond, repeat
steps 2 through 3, trying each code listed for
your brand until you find one that works.
If it still does not respond, try searching for
the code (see
Searching For Your Code
on the
next page).
5.
For future reference, write down each working
device code in the boxes below:
TV/VCR Code
TV Code
(if used)
10
Atlas XL Eng/Sp Manual 4/21/03 4:21 PM Page 10
