www.urcsupport.com
21
Restoring All Keymover Keys in a Single Mode
Restoring a Single Keymover Key
CLEARING CUSTOM PROGRAMMING
The C4000 and S4000 Remote Controls contains a
Custom Programming Reset
program. You can use it to
remove all custom programming, except your setup
codes and reassigned device keys.
IMPORTANT:
Executing this program erases all custom
settings for Volume Lock, Learned Keys,
Tune-In Keys, and Channel Lock. However,
your device programming remains.
1.
On the remote control, press
CBL
or
STB
once;
it blinks once. Then press and hold
SET UP
until the
CBL
key blinks twice.
2.
Enter
9 9 4
. The
CBL
(or
STB
)
key blinks
twice.
3.
Press and release the mode key you want to
clear twice. For example, to clear all Keymover
keys for the TV mode, press and release
TV
twice.
1.
On the remote control, press the mode key
once.
1.
Press and hold
SET UP
until the last-selected
mode key blinks twice (for example,
TV
).
2.
Enter
9 9 4
. The mode key blinks twice.
3.
Press and release the device key twice. For
example, to clear the CH+ key in TV mode,
press and release
CH+
twice.
1.
On the remote control, press and hold
SET UP
until the last-selected device key blinks twice.
2.
Enter
9 8 0
. The last-selected device key
blinks twice, pauses, and blinks twice again to
confirm that all custom programming is
cleared.
Generic Pioneer Charter OCAP.fm Page 21 Friday, July 20, 2007 1:28 PM