www.urcsupport.com/cricket
11
SETTING CABLE CONTROL
In the event that you need to update Cricket to control
your cable set-top-box, you can program the remote as
follows:
1.
While in
CHILD
or
ADULT
mode, hold down
both
MUTE
and
ON/OFF
for three seconds,
until the LED blinks twice.
2.
Enter
9 8 2
. The LED blinks 4 times.
3.
Put the 3-position switch in
Programming
mode.
4.
Press the
VOL -
key. The LED blinks twice.
5.
Find your
CBL/SAT
brand in the back of this
manual. Enter the first code for that brand
with the number keys on the remote. When
you press the fourth number key, the LED on
the remote blinks twice to confirm a valid
code.
6.
Slide the 3-position switch to
CHILD
or
ADULT
mode.
7.
Press
CH
S
to see if the set-top-box changes
channels. If the channel changes, the remote
control has been set.
8.
If the channel does NOT change, repeat steps
1 through 3 for the next code for that brand of
set-top-box.
9.
If the LED flashes one long blink, the entry
failed and must be repeated.
FCC NOTICE
This equipment has been tested and found to comply
with the limits for a class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equip-
ment and receiver.
Kids Remote 2006.fm Page 11 Tuesday, March 6, 2007 3:52 PM
