36
Programming a Learned Key
NOTE:
If more than 15 seconds pass between key
presses, the remote exits programming.
3.
Place the Atlas Shaw DVR/PVR 5-Device
Universal Remote Control head-to-head
(about 2" apart) from your original remote
control. Also locate the key (on your original
remote control) that you want the Atlas Shaw
DVR/PVR 5-Device Universal Remote Control
to learn.
4.
On the original remote, press and hold the key
to be learned. The Atlas Shaw DVR/PVR 5-
Device Universal Remote Control’s LED will
blink rapidly, then turn off. Continue holding
the key on the original remote until the Atlas
Shaw DVR/PVR 5-Device Universal Remote
Control’s LED blinks twice.
NOTE:
If the LED displays one long blink, a learning
error has occurred. Try repeating this step
again until a successful capture occurs. If the
function is
still not captured, press and hold
SETUP
to exit programming and review the
“Learning Precautions” on the previous page.
If needed, also see “Troubleshooting” on
page 21. After review, start programming
again at step 1.
1.
Press
SETUP
until the last-selected device key
blinks twice, then
9 7 5
.
NOTE:
If the LED displays one long flash instead,
either your batteries are low, or the Atlas Shaw
DVR/PVR 5-Device Universal Remote Control
has a memory fault. In either case, the remote
will not learn a new key. See “Additional Infor-
mation” on page 23.
2.
Press a device key once (i.e.,
AUX, DVD, AUD,
TV,
or
CBL
) to assign a mode for learning, then
the key that will learn the new code.
2"
Summary of Contents for M1055
Page 69: ...69 Vizio 1126 Voodoo 1272 ZT Group 1272 ...
Page 70: ...70 M11055 FS ...
