14
and write down the number in the
left-most
TV
Key Code box on
page 11.
NOTE:
If a code digit is 0, the power key
does not blink.
5.
Repeat step 4 three more times for
the remaining digits. Use
2
for the
second digit,
3
for the third digit,
4
for the fourth digit, and
5
for the
5th digit. Finish writing down the
code in the
TV
Key Code boxes on
page 11.
6.
To check for other device codes,
repeat steps 1 through 5, but
substitute the appropriate key (e.g.,
AUDIO
or
CBL/SAT
) for the device
you are checking. Write down the
codes in the appropriate boxes on
page 11.
Checking the PC Code
You may want to verify which of the three
PC addresses the MediaRemote with
SimpleCenter is currently using to
control receiver. To do so:
1.
On the remote control, press
PC
once; the power key blinks once.
2.
Press
and
(rewind and fast
forward) at the same time until the
power key blinks twice.
3.
Enter
9 9 0
. The power key blinks
twice.
4.
Press
1
and count the blinks. Use
the table below to interpret the
blinks, then note the code in the
box on page 12.
CONTROLLING SIMPLECENTER
Certain keys function differently when
you are using the
PC
mode to control
Simple Center:
# of Blinks
Code
1
41
2
42
3
43
Key
Function
(While playing music,
slideshows, or movies)
Cycle through Fast
Reverse
speeds (1x, 2x, 4x)
Media Remote Rev 1.fm Page 14 Monday, October 3, 2005 4:12 PM
