PROGRAMMING TV/VCR COMBO CONTROL
Locate the brand name of your TV/VCR Combo in the
Setup Codes For TV/VCR Combos
section below, and write
it in the following space.
TV/VCR Combo Brand: ________________________
The brands are listed in alphabetical order with popular
codes listed first.You will use one of these codes to pro-
gram the Millennium 3 to operate your TV/VCR Combo:
1.
Turn on your TV/VCR Combo and insert a
video cassette.
2.
On the Millennium 3, press
VCR
once. Press
and hold
SETUP
until the LED blinks twice,
then release
SETUP
.
3.
Enter the first four-digit code for your TV/VCR
Combo. If you perform this procedure correct-
ly, the LED will blink twice.
NOTE: If the LED did not blink twice after entering
the code’s last digit, then repeat steps 2 through 3 and
try entering the same code again.
4.
Aim the Millennium 3 at your TV/VCR Combo
and press
VCR
once. The unit should turn off. If
it does not respond, repeat steps 2-3, trying
each code listed for your brand until you find
one that works. If it still does not work, try
searching for the code (see
Searching For Your
Code
on page 22).
5.
If you’ve located a TV/VCR setup code that
works your TV/VCR Combo and a separate
TV code is also listed, you’ll need to program
this code into the Millennium 3 to access vol-
ume control (see
Programming TV Control on
page 8).
If there is no separate TV code listed, you will
need to perform the following steps to access
volume control:
a. Press and hold
SETUP
until the LED blinks
twice, then release
SETUP
.
b. Enter
9
-
9
-
3
. The LED will blink twice.
c. Press
VCR
once. The LED will blink twice.
16
Millennium 3 Mnl M3090 8/16/99 9:26 AM Page 16
