PROGRAMMING CABLE CONVERTER
(OR DBS RECEIVER) CONTROL
The Millennium 3 is preprogrammed at the factory to
operate the cable converter given to you by your cable
company. However, if you have another brand or model
of cable converter or satellite receiver that you would like
to control, then you’ll need to perform the following
instructions to unlock the cable key, enter in a new code,
and lock the cable key again.
To unlock the Cable key:
1.
Turn on the Cable Converter or DBS Receiver.
2.
On the Millennium 3, press
CBL
once. Press
and hold
SETUP
until the LED blinks twice,
then release
SETUP
.
3.
Enter
9
-
9
-
7
. The LED will blink twice.
4.
Press
CH –
once. The LED will blink twice.
To program the Cable key:
1.
Locate the brand name of your Cable Converter
(or Direct Broadcast Satellite Receiver) in the
Setup Codes For Cable Converters
(or
Setup
Codes For DBS Receivers)
section starting on the
next page, and write it in the appropriate space.
Cable Converter Brand: ________________
or
DBS Receiver Brand: __________________
The brands are listed in alphabetical order
with the most popular codes listed first.You
will use one of these codes to reprogram the
Millennium 3 to operate your Cable Converter
or DBS Receiver.
2.
On the Millennium 3, press
CBL
once. Press
and hold
SETUP
until the LED blinks twice,
then release
SETUP
.
3.
Enter the first four-digit code for your Cable
Converter or DBS Receiver. If you perform this
procedure correctly, the LED will blink twice.
NOTE: If the LED did not blink twice after entering
the code’s last digit, then repeat steps 2 through 3 and
try entering the same code again.
18
Millennium 3 Mnl M3090 8/16/99 9:26 AM Page 18
