14
Continue holding the key on the original
remote until the Atlas DVR/PVR IR/UHF
Remote’s LED blinks twice.
NOTE:
If the LED displays one long blink, a learning
error has occurred. Try repeating this step
again until a successful capture occurs. If the
function is
still not captured, press and hold
SETUP
to exit
programming and review the
“Learning Precautions” on the previous page.
If needed, also see “Troubleshooting” on
page 23. After review, start programming
again at step 1.
Deleting a Single Learning Key
This process returns the key to its original programming
for the mode you select. You can also delete learned
programming by teaching a different function to the key
(see “Programming a Learned Key” on page 13)
NOTE:
If more than 15 seconds pass between key
presses, the remote exits programming.
3.
Press the key containing the learned function
to be deleted twice. The mode key blinks
twice and exits from programming.
Deleting All Learned Keys in a Specific Mode
NOTE:
If more than 15 seconds pass between key
presses, the remote exits programming.
5.
Repeat steps 2 through 4 for another mode
and/or key or press and hold
SETUP
to exit
programming.
1.
Press and hold
SETUP
until the last-selected
mode key blinks twice, then press
9 7 6
.
2.
Press a mode key once (i.e.,
MTS, TV, DVD,
AUD,
or
AUX
).
1.
Press and hold
SETUP
until the last-selected
mode key blinks twice, then press
9 7 6
.
2.
Press a mode key twice (i.e.,
MTS, TV, DVD,
AUD,
or
AUX
) to clear all the learned keys for
that mode. The mode key blinks twice and
exits from programming.
