www.urcsupport.com
22
RE-PROGRAMMING SET-TOP BOX CONTROL
The Titan Remote Control comes pre-programmed to
control the set-top box supplied by your service
provider. In addition, it is locked to prevent inadvertent
deletion or change of set-top box control. In the event
that you need to change the STB key to control a
different brand/model of set-top box, follow these steps:
1.
Using the list of Manufacturer's Codes in the
back of this manual, locate the brand of set-
top box that you have and be prepared to enter
and test codes for step 5.
2.
Press
STB
once. It blinks once.
3.
Press and hold
SETUP
until the STB key blinks
twice
4.
Enter
9 8 2
. The STB key blinks four times
.
5.
Press and hold
SETUP
until the STB key blinks
twice.
6.
Enter the first code for your brand and type of
set-top box. The mode LED blinks twice.
7.
Test the code by pressing the
POWER
button
on the remote. If the set-top box responds,
you have the correct code and are finished.
8.
If the remote cannot control the set-top box,
follow steps 5-8, trying each code for your
brand until the remote can control the set-top
box.
SETUP
SETUP
Titan OCAP Remote Control.fm Page 22 Tuesday, May 27, 2008 1:55 PM
Summary of Contents for Titan
Page 55: ...www urcsupport com 55 NOTES ...
Page 56: ...M2056 C Revision 1 0 ...
