3
Maintenance
The filter and desiccant should be inspected every 8 hours of use. It may be necessary
to clean out the filter and change the desiccant that is inside the Dryer Assembly.
To inspect the filter, you must remove it. To inspect the desiccant you can observe the
color of the crystals through the slots in the metal enclosure without having to remove it.
If you start to see water droplets or moisture coming through the air lines, you will
definitely need to change the desiccant inside of the dryer assembly but it should never
get to that point. Indication that the desiccant needs changing is the lack of blue color
pigments in the desiccant. The desiccant can be regenerated. Bake it in an oven at 350
degrees F until some of the crystals turn blue again.
LOW
AUXIN
HIGH
Gauge
Needle Valves
Air
Gas
FILTER
DRYER
FITTING
SWITCH
FUSES
ON OFF AUTO
BLUE COILED HOSE
LEVER
CONTROL
WIRE
CONEXALL
FITTING
Laser System
