SYSTEM OPERATION
Section 3-4
SET FOCUS POSITION
Allows you to set the focus position anywhere in the field other than the factory default
setting of (1 inch, 1 inch). To change this setting, use the motion control arrow buttons to
position the focus carriage in the desired position. Then, bring the cursor down to the
YES SAVE POSITION line and press the SELECT. Press the ESCAPE button twice to
exit back to the MAIN menu to store this new setting.
SET ROTARY AXIS
This setting is pre-set at the factory. It is not necessary to change this setting unless you
are positioning the Rotary Fixture in a location in the engraving area other than the
factory default position. If you have purchased this option, please refer to the OPTIONS
and ACCESSORIES section of the manual for more information.
TICKLE
This is the term used to define the small pulses sent to keep the plasma inside the laser,
energized. It is not necessary to adjust this setting unless directed to so. Altering this
setting can produce adverse results.
PORTS
Two ports are provided on the back of the system for interface with a computer, a serial
and a parallel port. The factory default is already set to PARALLEL. Only one port can
be used at a time. If you would like to use the SERIAL port a special cable is required.
Please contact our Customer Service Department for more details.
LANGUAGE
Use the SELECT button to toggle through many different language choices. When the
desired setting is displayed, press the ESCAPE button twice to exit back to the MAIN
menu to store this setting before you power off the laser system.
UNITS
Use the SELECT button to toggle between INCHES and METRIC units. Once the
desired unit is displayed, press the ESCAPE key twice to exit back to the MAIN menu.
When the desired setting is displayed, press the ESCAPE button twice to exit back to the
MAIN menu to store this setting before you power off the laser system.
DIAGNOSTICS
This menu leads to other menus that help our Customer Service Department diagnose problems
with the laser system. Do not use this menu unless assisted by our Customer Service
Department or you have been trained on how to use it properly.
ALIGNMENT MODE
Used to manually fire the laser beam to determine if the laser systems optical alignment
is correct and check for maximum output power.
MEMORY
TEST
Tests the on-board RAM memory in the laser system.
MOTOR
STATUS
Displays the condition of the stepper motors in the motion system.
ABOUT
Displays the model, our copyright notice, and the current version of firmware.
Summary of Contents for SuperSpeed-660
Page 6: ......
Page 20: ...INSTALLATION Section 2 8...
Page 34: ...SYSTEM OPERATION Section 3 14...
Page 44: ...BASIC MAINTENANCE Section 4 10...
