BASIC MAINTENANCE
Section 4-2
Cleaning and Maintenance Supplies
•
Soap solution mixture of 1 tablespoon (2 cl) liquid soap and 1 quart (liter) of water in a spray bottle
•
Paper
towels
•
Cotton
cloth
•
Denatured alcohol (
NOT
to be used on any painted surface, plastic, or the Top Window)
•
Acetone (can be used on the engraving table but nowhere else)
CAUTION
When using acetone or denatured alcohol, please follow the instructions on the printed label of
these materials for safe handling procedures.
•
Cotton swabs (supplied)
•
Lens cleaner (supplied)
•
Vacuum
cleaner
•
Set of Allen wrenches sized from .050 to 3/16 inch
System Cleaning and Maintenance
Motion System
•
Turn off and unplug the laser system.
•
Open the top door and thoroughly remove all loose dirt and debris from inside the machine with a
vacuum cleaner.
•
Clean the engraving table surface with either a soap solution, or alcohol or acetone, and paper
towels.
NEVER
pour or spray any solution directly into the laser system. Always dampen your paper
towel or cloth outside of the machine with the cleaning solution and then wipe down the parts you are
cleaning with the dampened cloth.
•
Clean X-rail and the Y-rails by using either the cotton swabs or paper towels, and alcohol or soap
solution. Pay close attention to the bearing tracks since any debris left to build up in these bearing
tracks will cause the bearings to wear and the engraving quality to become rough.
•
After the rails and tracks are cleaned, use a clean swab or paper towel, and alcohol to clean all of the
bearings by holding the swab against each bearing and moving the motion system by hand to roll the
bearings against the swab. There are seven bearings in the system, three (3) on the focus carriage,
two (2) on the left side of the X-rail, and two (2) on the right side of the X-rail.
•
Clean the top window with a cotton cloth and the soap solution. The top window is made out of
acrylic.
DO
NOT
use paper towels because they will scratch the acrylic. Also,
DO
NOT
use window
cleaner, alcohol, or acetone, as these chemicals will crack the acrylic. Only use cleaners compatible
with acrylic.
•
Use a soft cloth or paper towels and the soap solution to clean the enclosure.
DO NOT
use alcohol,
acetone, or any other harsh chemical, as this will damage the paint.
Optics
A visual inspection of the #2 and #3 mirrors, beam window, and focus lens should be performed at least
once a day.
DO NOT clean an optic that is visually clean. Excessive cleaning can damage the
optic. To prevent contamination, wash your hands thoroughly before cleaning any
optic. NEVER touch any optic with your fingers. The acids from your skin can
destroy the optical coatings. NEVER clean any optic right after engraving or cutting
because the optic may be hot and the cool lens cleaning solution may thermally shock the optic
and crack it.
Summary of Contents for SuperSpeed-660
Page 6: ......
Page 20: ...INSTALLATION Section 2 8...
Page 34: ...SYSTEM OPERATION Section 3 14...
Page 44: ...BASIC MAINTENANCE Section 4 10...
