BASIC MAINTENANCE
Section 4-9
Operational
Focus carriage looses X-axis position
and slams into the left or right side of the
rail during high speed raster engraving
•
Mechanical interference
•
Dirty laser system
•
CPU overheating
•
X-belt too tight
•
Worn or binding X-axis bearings
•
Worn or binding X-axis idler pulley
•
Worn or binding X-axis motor
•
Firmware needs updating
•
Check if focus carriage makes
contact with material or other
objects
•
Clean all optics, rails, bearings and
belts
•
Clean CPU filters, correct ambient
temperature to be within
specifications
•
Check and/or adjust
•
Check and/or replace
•
Check and/or replace
•
Check and/or replace
•
Check with Service Department
When homing, the arm slams repeatedly
for a few seconds
•
Bent Y-flag
•
Dirty or faulty home sensor(s)
•
Check and/or straighten
•
Replace upper flex board
When focusing, the Z-axis table only
moves in one direction
•
Dirty or faulty Z-axis sensor
•
Try to clean sensor(s) with
compressed air, otherwise replace
sensor
When using Autofocus, the table moves
all the way down to the bottom and gets
stuck
•
Autofocus sensor or reflector is dirty
•
Autofocus sensor is misaligned
•
Clean sensor and/or reflector
•
With the Z-axis table out of the way
of the Autofocus beam, check the
sensor for only an illuminated green
light. A red light, both lights, or no
lights indicate a misalignment or
dirty condition. Clean, re-check, and
re-align the Autofocus sensor.
When printing to the laser system, the
computer gives an error message
“Printer out of paper” or “Printer offline
and not responding”
•
Laser not turned on
•
Computer is locked up
•
Parallel port cable not connected or
not connected properly
•
Laser system is out of memory
•
Single file is too large for memory
installed in laser system
•
Bad parallel port in computer system
•
Damaged port in CPU
•
Turn on laser system
•
Re-boot computer and laser system
•
Connect cable or reseat connection
at computer and/or laser system
•
Check “Free Memory” in laser
system control panel. Clear laser
system memory and try again
•
Purchase more memory
•
Try printing to another printer using
the same port
•
Replace laser system’s CPU
When running the laser system, the laser
system will “freeze”, the clock will keep
advancing, but the operator will have no
control over the system. The only way to
restore the system is to power the laser
off and then back on. This is a symptom
of file corruption.
•
Incorrect BIOS setting in computer
•
Using a printer cable longer than 6
ft.
•
Bad printer cable
•
Usage of device in between
computer and laser system
•
Some other parallel port driver
interfering with the laser system
printer driver
•
Bad Parallel port in the computer
•
Damaged port in CPU
•
Refer to manual on proper setting
•
Use only a 6 ft., IEEE1284
compliant printer cable
•
Replace printer cable
•
Connect the laser system directly
from computer with the printer cable
•
Remove all other parallel port
drivers and try again
•
Try another computer or change
parallel ports
•
Replace laser system’s CPU
Summary of Contents for SuperSpeed-660
Page 6: ......
Page 20: ...INSTALLATION Section 2 8...
Page 34: ...SYSTEM OPERATION Section 3 14...
Page 44: ...BASIC MAINTENANCE Section 4 10...
