52
13. If there is no burn then repeat Steps 10-12 until the paper has a faint burn spot. When a
burn spot is visible, go to Step 15.
14. When a hole is burned in the paper, lower Pulse Width one number using Steps 9 and 10
until the beam stops burning through the paper.
15. Turn system off and wait approximately 15 seconds.
16. Turn on system. Verify Pulse Width is 200 and Pulse Rate is 2000 and in Proportional
Mode.
OTE:
The motion system moves to the right and carriage to the rear of the system when
power is turned on.
17. Using DesignCAD or other software packages, draw a two inch square box.
18. Transmit drawing data from the computer. Engraving will begin. Note that marking will
be visible as individual dots. As marking continues, all dots should be visible and burning
the paper with the same intensity. If all the dots appear even and visible, tickle is properly
set. If, when starting a line of marking, some dots are missing, the Pulse Rate will have to
be changed. Tickle Pulse Rate Setting:
a.
Depress and release keypad "0".
b.
Depress and release keypad "Store".
c.
Depress and release keypad "1".
OTE:
Display will change from Pulse Width of 200 and Pulse Rate of 2000 to Pulse
Width of one or whatever was previously set and Pulse Rate of 200. The mode
(lower left corner of display) changes from a P to three stacked minus signs ( ).
19. a.
Depress and release keypad "Pulse Rate", lower display will begin to flash.
b.
Decrease the Pulse Rate by 25 (if display is flashing 200, depress on the keypad "1"
then "7" then "5").
c.
Depress and release keypad "Pulse Rate".
d.
Depress and release keypad "Store" and the display should go back into the program
mode and show a Pulse Width of 200 and Pulse Rate of 2000.
20. Open top door and move paper so that the next marking is done on a clean section of paper.
