Universal Laser Systems VLS2.30 User Manual Download

Page: 20 / 99

This section provides step-by-step instructions for site preparation, computer/software setup and laser system
assembly and connection. Follow the instructions in the order shown.

Site Preparation

Operating System Requirements and Software Installation

Assembling and Connecting Your Laser System

Note:

Make sure to complete step 2 (software installation) prior to plugging the laser system into a USB port

on your PC.

CAUTION:

Damage to the laser system due to inadequate or improper installation or operation is not

covered under the Universal Laser Systems (ULS) Warranty. See the ULS Warranty for additional
information. A ULS Warranty document is supplied with your laser system. Should you require a copy of the
Warranty, please contact the ULS Customer Service Team at 480-609-0297 (USA), +43 1 402 22 50
(Austria), +81 (45) 224-2270 (Japan) or e-mail us at support@ulsinc.com.

Please refer to the Safety section before operating your laser system.

Step 1: Site Preparation

Operating Environment (User Supplied)

1. The laser system must be installed in an office, laboratory, workshop or light duty manufacturing

environment.

2. Dusty or dirty environments can damage the laser system. Keep the laser system isolated from any

processes that produce airborne particles such as sandblasting, sanding, machining, etc. Also, keep the
laser system isolated from any equipment requiring mists of oil or water for lubrication. Airborne dust and
liquids can coat and damage optics and motion system components.

3. Avoid small, enclosed, non-ventilated areas. Some materials, after laser engraving or cutting, continue

emitting fumes for several minutes after processing. Having these materials present in a confined,
unventilated room can create a health hazard.

4. For best results, since the laser cartridges are air-cooled, we recommend operating the laser system

between the ambient temperatures of 70ºF (21ºC) and 78ºF (25ºC).

5. Avoid storing the laser system outside the temperatures of 50ºF (10ºC) and 95ºF (35ºC) as excessively

cold or hot temperatures can damage the laser cartridge or reduce its lifetime.

6. Ambient humidity levels must be non-condensing to protect optics.
7. The laser system should be at least 1 foot (300 mm) away from any wall or obstruction to allow for access

and proper ventilation.

Electrical Power Source (User Supplied)

1. For your system’s electrical requirements, please refer to the “INPUT POWER” label near the power inlet.

CAUTION:

Never remove the ground lead to the electrical cord and plug the laser system into a non-

grounded outlet. A laser system that is not properly grounded is hazardous and has the potential to cause
severe or fatal electrical shock. Without proper grounding, the laser system may exhibit sporadic or
unpredictable behavior. Always plug the system into a properly grounded (earthed) outlet.

3. Noisy or unstable electricity and voltage spikes may cause interference and possible damage to the

electronics of the laser system. If electrical power fluctuations, brown outs or constant power outages are
a problem in your area, please contact your local Electrician to supply a power isolation and regulation
module. Electrically noisy equipment, such as equipment with large motors, can also cause interference if
plugged into the same outlet. It may be necessary to attach the laser system to a dedicated electrical line
to resolve the problem.

4. The laser system is designed as a Class I, Group A, pluggable device. It is also designed for connection

to IT Power systems which provide the most flexibility to the user.