Goodrive10 inverters Function codes
29
Function
code
Name
Detailed instruction of parameters
Default
value
Modify
command - B frequency command
4: Max (A, B): The bigger one between A frequency
command and B frequency is the set frequency.
5: Min (A, B): The lower one between A frequency
command and B frequency is the set frequency.
Note:
The combination manner can be shifted by
P05(terminal function)
P00.10
Keypad set
frequency
When A and B frequency commands are selected as
“keypad setting”,
this parameter will be the initial value of
inverter reference frequency
Setting range:0.00 Hz~P00.03(the Max. frequency)
50.00Hz
○
P00.11
ACC time 1
ACC time means the time needed if the inverter speeds up
from 0Hz to the Max. One (P00.03).
DEC time means the time needed if the inverter speeds
down from the Max. Output frequency to 0Hz (P00.03).
Goodrive10 series inverters define four groups of ACC/DEC
time which can be selected by P05. The factory default
ACC/DEC time of the inverter is the first group.
Setting range of P00.11 and P00.12:0.0~3600.0s
Depend
on model
○
P00.12
DEC time 1
Depend
on model
○
P00.13
Running
direction
selection
0: Runs at the default direction, the inverter runs in the
forward direction. FWD/REV indicator is off.
1: Runs at the opposite direction, the inverter runs in the
reverse direction. FWD/REV indicator is on.
Modify the function code to shift the rotation direction of the
motor. This effect equals to the shifting the rotation direction
by adjusting either two of the motor lines (U, V and W). The
motor rotation direction can be changed by QUICK/JOG on
the keypad. Refer to parameter P07.02.
Note:
When the function parameter comes back to the
default value, the motor’s running direction will come back
to the factory default state, too. In some cases it should be
used with caution after commissioning if the change of
rotation direction is disabled.
2: Forbid to run in reverse direction: It can be used in some
special cases if the reverse running is disabled.
0
○
