4
5
Operating Instructions for the 8 in 1 Universal Remote
Control Unit
Thank you for purchasing your new 8 in 1 Universal Remote Control Unit.
Your new remote control unit contains one of the largest infrared code library for the control of a
maximum of 8 different devices obtainable in Europe.
This remote control unit is preprogrammed, in other words all you have to do is enter into it the
type of device (for example a TV from Sony) which you wish to control.
The 8 in 1 Universal Remote Control Unit is suitable for the control of practically all common
makes of Television Set (TV), DVD Players (DVD), (digital) Satellite Receivers (SAT), Video
Recorders (VCR), Tuners (Tuners), CD Players (CD), Cassette Recorders (TAPE), Amplifiers
(AUX).
The 8 in 1Universal Remote Control Unit controls all the essential basic functions of your devices.
Please read these operating instructions before using your new 8 in 1 remote control unit.
Setting up procedure:
To make your remote control unit ready for use
you need to carry out the following steps:
A. Set-Up by
brand codes:
1. Make sure that you have installed 2 new
batteries (type „AAA”) correctly into your
new remote control.
2. Turn on the device which you would like to
control (e.g. TV set).
3. In the back section of this manual you find
the name of your device brand. Search for
the brand of the device you would like to
control and note the required codes (e.g.
PHILIPS TV you will find 001, 004, 016,
etc).
Remark:
If the brand name of your
television is not listed in the device brand
code list, first try the 3-digit codes, which
are listed under „Philips” TV.
4. Press and hold down the SET key and actu-
ate the device key (TV). The LED lamp of
the device key lights up and signals to you
the set-up mode. Release both keys.
5. Enter now the 3- digit device code (e.g.
001 for PHILIPS TV). If no entry is made
within 10 seconds, the set- up mode is au-
tomatically terminated.
6. The LED lamp will be turned off, if this
code is accepted by the remote control unit.
If the LED lamp flashes once, this code is
not accepted and the remote control unit is
still in set-up mode. In this case enter the
next code from the list.
7. Check the functionality of the keys. If
some keys on your new remote control unit
do not work correctly, try one of the other
3-digit device codes from the list. Repeat
steps 4. to 7. until all the basic functions
operate properly.
Remark:
To leave set-up mode, press the
device key (TV). The set-up mode discon-
tinues automatically, if none of the keys
was pressed within 6 seconds.
B. Set-Up by
auto search:
If set- up with brand name codes is unsuccess-
ful, you can use the „Automatic search” func-
tion to establish the correct code for operating
your device.
1. Turn ON the device you would like to con-
trol. If it is a video recorder insert a video
tape.
2. Point the remote control unit at your de-
vice. Press the SET and the device (e.g.
GB
