PROGRAMMING DEVICE CONTROL
The Atlas DVR/PVR 5-Device Universal Remote Control
is preprogrammed to operate the Scientific Atlanta cable
box (converter) provided by your cable system, an RCA
TV, a Toshiba DVD player, an RCA VCR (as an
AUX
device), and a Pioneer audio receiver. To control devices
other than the default brands, perform the following steps;
otherwise skip this section:
NOTES: For TV/VCR Combo control, skip this section and perform
the instructions on page 12. Also refer to the “Device Table” on
page 8 to find out which devices can be programmed onto each
device key.
If you have another brand of cable converter or a satellite receiver
you would like to control, you’ll first need to unlock the cable ID
Lock before changing the converter code – see “Programming ID
Lock” on page 16.
1.
Turn on a device and, if applicable, insert
video media, (e.g., cassette or disc).
NOTE: Please read steps 2 through 4 completely
before proceeding. Highlight or write down the codes
and device you wish to program before moving on to
step 2.
2.
On the remote control, press a device key once
(i.e..,
AUX
,
DVD
,
AUD
,
TV
, or
CBL
); it will blink
once. Then press and hold
SETUP
until the
selected mode key blinks twice, then release
SETUP
.
3.
Use the
Manufacturer’s Codes
(starting on
page 24) to locate the the type of device and
brand name and then enter the first four-digit
code for your device. If performed correctly,
the selected mode key will blink twice.
NOTE: If the selected mode key emits a long blink,
the entry is invalid. Repeat steps 2 through 3 and try
entering the same code again.
4.
Aim the remote control at the device and
press
PWR
once. The device should turn off.
If it does not, repeat steps 2 through 3, trying
each code for your brand until you find one
that works. If it still does not respond, try
searching for the code (see
Searching For Your
Code
on page 13).
NOTE: If the device does not have a
POWER
key,
press the
(
Play
) key.
10
Atlas DVR-PVR M1055 8/12/04 4:51 PM Page 10
