PROGRAMMING TV/VCR COMBO CONTROL
If you own a TV/VCR Combo, perform the following
instructions to control this device:
1.
Turn on your TV/VCR Combo and insert a
video cassette.
2.
On the remote control, press
AUX
once; it will
blink once. Then press and hold
SETUP
until
the
AUX
key blinks twice, then release
SETUP
.
3.
Use the
Setup Codes For TV/VCR Combos
(on
page 36) to locate the brand name and then
enter the first four-digit code for your TV/VCR
Combo. If you perform this procedure
correctly, the
AUX
key will blink twice.
NOTE: If the
AUX
key did not blink twice after
entering the code’s last digit, then repeat steps 2
through 3 and try entering the same code again.
If you’ve located a TV/VCR setup code that
works for your TV/VCR Combo and a separate
TV code is also listed, you’ll need to program
this code into the remote control to access
volume control (see
Programming Device
Control
on page 10).
4.
Aim the remote control at your TV/VCR
Combo and press
PWR
once. The device
should turn off. If it does not respond, repeat
steps 2 through 3, trying each code listed for
your brand until you find one that works.
If it still does not respond, try searching for
the code (see
Searching For Your Code
on the
page 13).
5.
For future reference, write down each working
device code in the boxes below:
TV/VCR Code
TV Code
(if used)
12
Atlas DVR-PVR M1055 8/12/04 4:51 PM Page 12
