CHECKING THE CODES
If you have set up the Atlas DVR/PVR 5-Device Universal
Remote Control using the
Searching For Your Code
procedure (on the previous page), you may need to find
out which four-digit code is operating your equipment.
For example, to find out which code is operating your TV:
1.
On the remote control, press
TV
once; it will
blink once. Then press and hold
SETUP
until
the
TV
key blinks twice, then release
SETUP
.
2.
Enter
9
-
9
-
0
. The
TV
key will blink twice.
3.
To view the code for the first digit, press
1
once.Wait 3 seconds and count the number
of times the
TV
key blinks (e.g., 3 blinks = 3)
and write down the number in the leftmost
TV Code box on page 11.
NOTE: If a code digit is “0”, the selected mode key
will not blink.
4.
Repeat step 3 three more times for the
remaining digits. Use
2
for the second digit,
3
for the third digit, and
4
for the fourth digit.
Finish writing down the code in the TV Code
boxes on page 11.
5.
To check for other device codes, repeat steps
1 through 4, but substitute the appropriate key
(e.g.,
AUX, DVD, AUD,
or
CBL
) for the device
you are checking.Write down the codes in the
appropriate boxes on page 11.
14
Atlas DVR-PVR M1055 8/12/04 4:51 PM Page 14
