16
PROGRAMMING ID LOCK
The Atlas DVR/PVR 5-Device Universal Remote Control
is locked at the factory to operate a Scientific Atlanta
cable converter. However, if you have another brand or
model of cable converter or satellite service that you
would like to control, then you’ll need to perform the fol-
lowing steps to unlock the
ID Lock
, enter in a new manu-
facturer’s code, and lock the
ID Lock
again.
1.
Turn on the cable converter.
2.
On the remote control, press
CBL
once; it will
blink once. Then press and hold
SETUP
until
the
CBL
key blinks twice, then release
SETUP
.
3.
Enter
9
-
8
-
2
. The
CBL
key will blink
four times, indicating
ID Lock
is unlocked.
4.
Perform the instructions in
Programming
Device Control
on page 10 to program device
control for the desired cable converter or
satellite receiver. Upon completion, perform
the remaining steps (5 and 6 on this page) to
again lock the
ID Lock
.
5.
On the remote control, press
CBL
once; it will
blink once. Then press and hold
SETUP
until
the
CBL
key blinks twice, then release
SETUP
.
6.
Enter
9
-
8
-
2
. The
CBL
key will blink twice,
indicating
ID Lock
is again locked.
PROGRAMMING “TUNE-IN” KEYS
FOR SPECIFIC CHANNELS
The Atlas DVR/PVR 5-Device Universal Remote Control
includes three “
Tune-In
” keys (located directly below the
MUTE
and
LAST
keys). Each can be programmed to
remember five of your favorite cable channel settings for
a total of nine channels. If you want to change the cable
channels in a previously-programmed “
Tune-In
” key,
you’ll need to clear the key first (see next page).
Atlas DVR-PVR M1055 8/12/04 4:51 PM Page 16
