17
To Program A “Tune-In” Key:
1.
On the remote control, press
CBL
once; it will
blink once. Then press and hold
SETUP
until
the
CBL
key blinks twice, then release
SETUP
.
2.
Enter
9
-
9
-
5
. The
CBL
key will blink
twice. Then select a “
Tune-In
” key and press
it once.
3.
Press
CBL
once followed by the channel
number to be programmed (e.g.,
3
-
9
).
NOTE: If you are programming a channel for a
Digital Cable Converter, you need to enter all
channels in a 3-digit channel format. For example,
if the desired channel is
39
, then enter it as
0
-
3
-
9.
4.
Press and hold
SETUP
until the
CBL
key blinks
twice, then release
SETUP
.
5.
To add another channel, repeat steps 1
through 4, substituting the new channel to be
added in step 3.
NOTE: Programming more than five channels on the
same “
Tune-In
”key will overwrite previous settings.
To Clear A “Tune-In” Key:
1.
On the remote control, press
CBL
once; it will
blink once. Then press and hold
SETUP
until
the
CBL
key blinks twice, then release
SETUP
.
2.
Enter
9
-
9
-
5
. The
CBL
key will blink
twice. Then select a “
Tune-In
” key you want to
clear and press it once.
3.
Press and hold
SETUP
until the
CBL
key blinks
twice, then release
SETUP
.
4.
This “
Tune-In
” key is now clear and ready for
reprogramming (see above –
To Program A
“Tune-In” Key
). If desired, repeat steps 1
though 3 in this section to clear another
“
Tune-In
” key.
Atlas DVR-PVR M1055 8/12/04 4:51 PM Page 17
