10
T h e C u s t o m i z e r
Learning Method
The Customizer can learn commands from your old
remote controls one-button-at-a-time by following
these simple steps:
Line-up the Customizer with your old remote
control, head-to-head, one or two inches apart.
Press and hold the MAIN and ENT (Enter) buttons
at the same time for approximately three seconds.
The top of the display will show “SETUP”. You are
in SETUP mode now.
Note:
You have 30 seconds to perform a step while you are
in SETUP mode. If you don’t press a button within that time,
the Customizer will time out and return to normal operation.
Press the LEARN button.
The top of the screen will change to “LEARN”.
1
2
3
LEARN
Button
Summary of Contents for Customizer URC-300
Page 1: ...Owner s Manual...
Page 54: ...52 T h e A u t o m a t o r M E M O...
Page 55: ...53 T h e A u t o m a t o r M E M O...
Page 56: ...OCE 0025A Rev 04...