Download and Test All Learned Buttons
This time when you download, make sure that you choose FULL DOWNLOAD, otherwise your learned codes will not
download to the remote control.Test all the learned buttons, and go ahead and correct the problems as you find
them.
Learning Standalone
After a FULL Download from a recently LIVE UPDATED MXEditor, the MX-700 and the MX-800 have a new fea-
ture, Learning without connections to a PC.The stand alone learning feature was added because:
1
1 Some PC/Windows combinations create lags in timing that make learning via the PC difficult.
2
2 Sometimes the PC is not a laptop and is in another room from the components, making testing difficult.
3
3 During testing of codes, it is convenient to touch things up on the remote and then upload the corrected
file.
S
Sttaan
nd
d A
Allo
on
ne
e L
Le
eaarrn
niin
ngg S
Stte
ep
p b
byy S
Stte
ep
p
Before using the standalone Learning feature, you should use the LCD Button Editor
(Program Menu Step #3) to label all buttons appropriately.There is no standalone Labeling
feature. Once all of your buttons are labeled, save the file on your pc and perform a full
download to the remote control.
1
1 Disconnect the remote from the PC after completing a Full Download.
2
2 Press and hold the MAIN button on the remote control.While holding the
MAIN button down, press and hold the ENT button (on the bottom left corner
of the remote control. Continue to hold until the SETUP menu appears,
approximately ten seconds.
2
27
7
S
Stte
ep
p b
byy S
Stte
ep
p T
Tu
utto
orriiaall
M
X
8
0
0
M
X
7
0
0
M
X
2
0
0
R
E
M
O
T
E
S
