Page 19
AUX Function: Programming
a 7th Component
After you’ve finished programming the WR7 for six
primary components and you did not use AUX, you
can take advantage of the AUX function to program
a 7th component, such as a second TV, DVD, or
any other audio/video component that you may
have in your system. Simply program the [AUX] but-
ton in the same manner as any other component
using either the Quick Set-Up Method, the 3-Digit
Code Entry Method, the Auto-Search Method or the
Learning Method.
Finding a Component’s
Set-up Code Number
If you used the Auto--Search or Learning Methods
to program a component, you may not know the
code number you programmed. Here is a way for
you to identify what that code number is, so you
can make a note in the back of this Manual for
future reference.
STEP 1:
Press the component button you
would like to verify and the SELECT [SEL]
button at the same time for two seconds until
the selected component LED light turns on.
IMPORTANT:
You have 30 seconds to
perform the next step while you are in pro-
gramming mode. If you do not press a but-
ton within 30 seconds, the component LED
light will turn off.
The remote will exit the programming mode
and you will have to start over.
COMPONENT
BUTTONS
SELECT
INFO
Summary of Contents for OCE-0085A
