TRF-ZW2 Buttons
Sync Button
To carry out a manual setup of devices, tap the Sync button on the
controller. To exit the inclusion mode on the controller, tap the
Sync button again. To exclude a Z-Wave product from the network,
hold the Sync button down for 3 seconds. (Figure 2-1)
WPS Button
Easy push button inclusion for Wi-Fi devices.
(Figure 2-1)
Reset Button
The URC controllers can be reset to factory defaults by
holding the reset button for 20 seconds and releasing it. This will
reset the Z-Wave network and change it’s House ID, and clear your
account and user configuration data from your controller.
The account will only be removed from the controller, but it will
continue to be in the database.
Holding the reset button for 10 seconds will reset the network
configuration settings to defaults, while keeping your other
settings intact. (Figure 2-1)
Note:
If this controller is the primary controller for your network,
resetting it will result in the nodes in your network being orphaned and
it will be necessary after the reset to exclude and re-include all of the
nodes in the network. If this controller is being used as a secondary
controller in the network, use this procedure to reset this controller
only in the event that the network primary controller is missing or
otherwise inoperable.
A
B
C
Figure 2-1:
TRF-ZW2 Side
A
B
C
Service
Z-Wave
Wi-Fi
WAN
Power
Summary of Contents for TRF-ZW2
Page 1: ...i TRF ZW2 Z Wave Gateway Owner s Manual ...
Page 17: ...14 Notes ...
Page 19: ...TRF ZW2 Controller Z Wave Overview Guide ...
Page 26: ......
