……………………………………………………………………………………………………
16
You can set up a Macro operation by following steps:
1. Press and hold the
key for more than
3
seconds, and then release it.
2. Press the
or
key to select “
MACRO
”, and then press the
key.
3. Press the
or
key to select the “
MACR O1
” (or Macro2 or Macro3),
then press the
key.
4. The screen shows “
SET UP
”, and then press the
key.
5. LCD shows “
SELECT KEY
”, then you can select the device and function key for a
sequent operation that you like.
e.g.:
TV
+
POWER
+
MUTE
+
AV
,
+DVD
+
PLAY
, +
VCR
+
RECORD
, etc. That means you want to
turn on the TV and shut off it
¶
s sound, switch TV input to AV port, at the same time DVD starts
to play, VCR begins to record
6.Press the
key to save the setting, LCD shows “
SUCCESS”
then exit to current
setup state,
7.You can press any device key to finish set up or press the
key to last state and
use
or
to select other set up.
SET 3S
Input sequent operation, then press OK
Remark:
1. A new Macro set up will erase and cover the last programmed Macro.
2.You can set up to maximum 10 commands in a Macro.
3. During operating Macro, be sure point your remote control to your appliance until
finish this operation.
4..Be sure all the keys included in MACRO can send out signals, otherwise even if
you programmed these keys inside the MACRO, it still can’t work properly when
you operate this function. You can check those keys by pressing them to see the
relative
Device
buttons flash or not before you set up into MACRO.
5. Be sure the device must have relative conditions when you operate MACRO
function. For example the disc must be put in the DVD player and a video tape
must be put in the VCR when you like to play the DVD or make a record by your
VCR by Macro operation.
T V 0 1 0
1 1 : 4 5
A M
M A C R O
C O D E S E T U P
S E T U P
M A C R O 1
S E L E C T K E Y
S U C C E S S
