Universal Scientific Industrial Co. AP-AG-AT-02, User Manual

12

NOTE: 

The button labeled “Reset” enables you to restart the Access Point. 

This is used when the system is Halt. Please press the “

Reset

” button on the 

back panel of the Access Point.   
of the Access Point.   
 

Antenna Connector 

The Wireless LAN Access Point supports extension range antennas. To 
connect the extension antennas, please open the case and install the 
hardware.

2-4 Hardware Installation   

Take the following steps to set up your Access Point. 
 

Site Selection 

Before installation, determine the Access Point location. Proper 
placement of the Access Point is critical to ensure optimum radio range 
and performance. You may use the Site Survey and Access Points 
Browser utility (The utilities came with the wireless PC Card) to choose a 
proper placement for your Access Point. Typically, the best location to 
place your Access Point at your site is the center of your wireless 
coverage area. Try to place your mobile stations within the line of sight. 
Obstructions may impede performance of the Access Point. 

Connect the Ethernet Cable 

The 802.11a/g WLAN Access Point supports 10/100M Ethernet