FLORIDA-PNEUMATIC.COM
Please contact 1-800-356-3392 for further assistance.
Operation
1
Operating the drill
□
This 1/2" Reversible Pistol Grip Drill is designed to operate
on 90 PSIG. Lower pressure (below 90 PSIG) will reduce
performance of the tool. Higher air pressure (over 90
PSIG) raises the performance of the tool beyond its rated
capacity and could cause serious damage to tool and user.
2
Changing the rotation direction
□
The direction of the bit rotation is reversible.
□
Control the rotation direction by moving the side-mounted
switch to F (forward) or R (reverse) as required for the
operation.
3
Installing and removing the bits
WARNING:
Disconnect tool from air supply before servicing
or changing accessories.
To install the bits:
□
Remove the air supply from the reversible drill.
□
Insert the drill bit as far as possible into the opening.
□
Using an appropriately sized chuck key, turn the chuck key
clockwise to securely tighten the drill bit, tap, or reamer in
the drill chuck.
□
Always remove the chuck key before connecting the drill to
the air line.
To remove the bits:
□
Remove the air supply from the reversible drill.
□
Using an appropriately sized chuck key, turn the chuck key
counterclockwise to loosen the drill bit, tap, or reamer in
the drill chuck.
□
Remove the bit.
□
4
Drilling
Place the rotation direction forward position.
Hold the drill with one hand.
Place the bit head onto the surface and slowly depress the
switch trigger. Start the bit slowly for more control.
