Distributor
Notes
Page No 8
Declaration of Conformity
Universal Air Tool Company Limited
Unit 8, Lane End Industrial Park, High Wycombe, Bucks, HP14 3BY, England
declare under our sole responsibility that the product
Model UT59A Touch Up Spray Gun, Serial Number
to which this declaration relates is in conformity with the following standard(s) or other normative document(s)
EN792 (Draft), EN292 Parts 1 & 2, ISO 8662/1
following the provisions of
89/392/EEC as amended by 91/368/EEC & 93/44/EEC Directives
Place and date of issue
Name and signature or equivalent marking of authorised person
Lane End
D.H.Moppett (Man. Director)
This document may not be copied wholly or in part by anyone without the consent of the Directors of Universal Air Tool Company Limited
©Copyright of Universal Air Tool Company Limited, established in the United Kingdom, 1994
Designed & Written in the U.K.
Safety Rules
Do not assume
that you are totally familiar with this unit until after
having read all warning tags, labels, nameplates, instruction sheets and
any other explanatory material completely and thoroughly. To avoid
accidents, this should be done by all persons before attempting to
operate, assemble or disassemble the gun or any other part of the
system.
Before disassembly or removal of any part of the gun or attached
components; shut off compressor, release pressure by depressing the
trigger and disconnect power source.
Never
assume system pressure is zero!
Protect all lines against damage.
Avoid Risk
. If uncertain as to safe
conditions of hoses, replace with the same type of a suitable
replacement. (
Do Not
Repair).
To avoid creating an explosive atmosphere, work only in a well
ventilated area.
Use of a face mask is recommended to prevent inhalation of toxic
material.
Do Not attempt to unclog (back flush) spray gun by squeezing trigger
while holding your finger in front of the fluid nozzle.
Pressure may vary according to viscosity of material used. Maximum
working pressure is 40 psi.
Do not exceed pressure limit of gun or any other component
in syst
em.
Prior to daily operation, make certain that all connections and fittings are
secure.
Check hose and all connections for weak or worn condition that could
render system unsafe. All replacement components such as hose or
fittings
must
have a working pressure equal to or greater than system
pressure.
Recommended spray distance 8” to 10”.
Warning
Halogenated hydrocarbon solvents for example: 1,1,1- trichloroethane
and methylene chloride- can chemically react with the aluminium in this
gun and cause an explosion hazard. Read the label or data sheet for the
material you intend to spray. Do not use spray material containing these
solvents with this spray gun.
Accessories
ARTHUR PATERSON
