Recoilless Needle Scaler
UT9912
Description
The Universal Tool model UT9912 Recoilless Needle Scaler features a patented vibration dampening system. The low
vibration and high blow frequency results in less operator fatigue and increased production. This versatile tool is used on
flat and irregular surfaces for removing weld flux, paint, rust, scale and to resurface concrete.
PL-2079
FPMC
Read Operating Instructions
Always become familiar with all the instruc-
tions and warnings before operating any
pneumatic tool.
Always Wear Approved Eye Protection
Impact resistant eye protection should meet
or exceed the standards as set forth in the
United States ANSI Z87.1, Occupational and
Educational Eye and Face Protection. Look
for the marking Z87.1 on your eye protection
to insure that it is an approved style. For
further information, ANSI Z87.1, Occupa-
tional and Educational Eye and Face
Protection, is available from the American
National Standards Institute, Inc., 11 West
42nd Street, New York, NY 10036.
Hearing Protection is Recommended
Hearing protection should be used when the
noise level exposure equals or exceeds an 8
hour time-weighted average sound level of
85dBA. Process noise, reflective surfaces,
other tools being operated nearby, all add to
the noise level present in your work area. If
you are unable to determine your noise level
exposure, we recommend the use of hearing
protection.
Avoid Prolonged Exposure
to Vibration
Pneumatic tools can vibrate during use.
Prolonged exposure to vibration or very
repetitive hand and arm movements, can
cause injury. Stop using any tool if discom-
fort, tingling feeling or pain occurs. You
should consult your physician before
resuming use of the tool.
90 PSIG Maximum
This tool is designed to operate at an air
pressure of 90 pounds per square
i
nch
gauge pressure (90 PSIG) maximum, at the
tool. Use of higher air pressure can, and may
cause injury. Also, the use of higher air
pressure places the internal components
under loads and stresses they were not
designed for, causing premature tool failure.
The air supply should be clean and dry,
preferably lubricated. For best results, drain
the moisture from your compressor daily.
PLEASE READ AND FOLLOW ALL WARNINGS
Specifications
Number of needles ....................................................... 18
Needle size .........................................................
Ù
" X 7"
Blows per minute ..................................................... 9000
Stroke length ............................................................... ¼"
Vibration level ....................................................... 3 m/s
2
Overall length .......................................................... 12¼"
Weight ................................................................. 4¼ lbs.
Air inlet ...............................................................
¼
" NPT
Hose size .............................................................
Ú
" I.D.
Average air consumption ....................................... 3 CFM
Maximum operating pressure ................................ 90 PSI
Universal Tool
A Division of Florida Pneumatic Manufacturing Corporation
851 Jupiter Park Lane, Jupiter, Florida 33458
Toll Free 1-800-327-9403
WARNING
: SOME DUST CREATED BY POWER SANDING, SAWING,
GRINDING, DRILLING, AND OTHER CONSTRUCTION ACTIVITIES
CONTAINS CHEMICALS KNOWN TO CAUSE CANCER, BIRTH
DEFECTS OR REPRODUCTIVE HARM. SOME EXAMPLES OF THESE
CHEMICALS ARE:
LEAD FROM LEAD-BASED PAINTS
CRYSTALLINE SILICA FROM BRICKS, CEMENT AND OTHER
MASONRY PRODUCTS
ARSENIC AND CHROMIUM FROM CHEMICALLY TREATED LUMBER
YOUR RISK FROM THESE EXPOSURES VARIES, DEPENDING ON
HOW OFTEN YOU DO THIS TYPE OF WORK. TO REDUCE YOUR
EXPOSURE TO THESE CHEMICALS, WORK IN A WELL VENTILATED
AREA AND WORK WITH APPROVED SAFETY EQUIPMENT SUCH AS
THOSE DUST MASKS THAT ARE SPECIALLY DESIGNED TO FILTER
OUT MICROSCOPIC PARTICLES.
