4: Setting up the Futura Pro Remote:
•
The Futura Pro Remote needs to be taught directly to the Active Unit (
MiniGAP (OMG)
Unit,
Basic Access
(OMG2)
Unit, or
Push-To-Exit
(OPE)
Unit)
•
To put the Futura Pro Remote in Learn Mode, press the
large
button, button
2
and button
4
at the
same time, for
1 second
and
release
.
•
On the OMG, OMG2, or OPE, press and release the black learn button located inside the unit on
the circuit board.
-
The remote led will blink 3 times slowly, indicating success.
-
Proceed to
Step 6
.
!
Clearing the Memory
If you get an error tone at any time or need to re-teach a unit, you will need to clear the memory.
•
To clear the memory on an Ultra RX 900, hold down the learn button, located on the inside of the
unit, until the LED gives blinks 4 times, twice.
•
To clear the memory on a GCU, hold down the learn button until the LED gives 4 double blinks.
•
To clear the memory on a MiniGAP, Basic Access or Push-To-Exit, hold down the learn button
until you hear a low tone.
•
To clear the memory on an Futura Pro Remote, press the
large
button, button
2
and button
4
at the
same time until the led lights up.
General Operation
5: Using the Futura Pro Remote with the ULTRX900-R in receiver mode:
•
Once the Futura Pro Remote has been taught to the Ultra RX 900 unit, the buttons will
automatically operate as follows:
Large Button – Activates Relay #1
Button #2 – Activates Relay #2
Button #3 – Activates Output 3
Button #4 – Activates Output 4
See the ULTRX900-R Instruction manual for more detailed instructions.
6: Using the Futura Pro Remote with an Active Unit:
•
Once the Futura Pro Remote has been taught to a GAP, Keypad, MiniGAP, Basic Access, Push-To-
Exit, or DFGCU, the buttons will automatically operate as follows:
Large Button – Activates GCU #1
Button #2 – Activates GCU #2
Button #3 – Activates GCU #3
Button #4 – Activates GCU #4
Note: If the Futura Pro Remote has activated GCU 2, 3, or 4, and one of those GCU’s is removed from the
network, the corresponding button, if pressed, will give a 6 tone error signal.
If there is only 1 GCU, then buttons 2, 3, & 4, will do nothing.
3
FCC STATEMENT
This device complies with FCC part 15 rules. It may not cause harmful interference with other devices, and must accept interference from other devices.
NOTE:
The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Changes or
modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Warranty
: This product is warranted to be free of defects for the period of
One Year
from the date of purchase.
The warranty covers parts, labor, and return
shipping to you, but not all accessories
. IEI will repair or replace any defective product at our discretion. Warranty does not cover misuse or damage other than due to
normal operating conditions. If you need to send the system to IEI for repair, contact IEI for a
Return Authorization number via email: techsupp@nwlink.com.
Packages without a Return Authorization number will be rejected.
Universal Wireless Solutions
Designed and Manufactured In the USA.
A manufacturer’s full One Year Warranty covers this product
.
See www.WirelessGateAccess.com for technical information and questions
