MRf-350 b
ase
s
TaTiOn
Page 12
Frequently Asked Questions
Can i use flasher/emitters that i have already installed in the system to con-
nect to the MRf-350?
Yes, the flashers are compatible if they use 3.5mm mono mini plugs with the same
polarity (Tip is data, sleeve is ground).
i’m getting inconsistent operation regardless of flasher level or position.
Some components are easily overloaded with IR from nearby flashers. Prevent IR from
affecting the problem component from other flashers or the front panel blaster by set-
ting the device to a specific IR Line Output instead of ALL, then adjust the Line Output.
i have a row of identical TVs. i’ve co rrectly set the flasher outputs using the
editor software, yet when i send a command to one of them, the TV next
to the selected TV also responds. how do i stop this?
First, check the RF ID#, if the RF ID# is set to 0, IR routing does NOT work. The RF ID#
from 1-9 or A-F must be set on both the remote control and the bottom of the MRF-
350, second, check that the flasher level is set to the minimum necessary, third, check
that the emitter is facing the component, fourth, make sure the RFX-250 is correctly
connected to the MRF-350 RF Inputs (Step 4, Page 3)
