DO NOT CARRY OUT ANY MAINTENANCE OR CLEANING WITH ELECTRICITY
CONNECTED
All bearings and transmission parts are lubricated for life. Keep the mixer clean to
avoid flour from depositing in the moving parts thus generating bothersome creaking
and abnormal wear.
To tension the belt,
remove the upper
casings, loosen the
motor bolts and act on
the appropriate register.
Fasten the motor bolts,
place the casings back
and test the machine.
*See Diagram below
Problems with the grid
micro switch: remove
the upper protection
casing, adjust the
micro switch position
close the casing again
and test the machine.
Should a power cable
be damaged, replace
it with a
H07RN/F
cable with a 3x1.5
mm2 section
Cleaning:
the
mixer is not
water-proof. Do not wash it
with running water/hose. Clean
it with a moist cloth and neutral
detergents. Do not use excess
amounts of water as it is hard
to remove from the bowl.
To tension the chain
and the lower bowl
drive chain, remove
the lower casing (tilt
the machine) and act
on the appropriate
registers. Replace the
casing and test the
machine
*See Diagram below
Electrical issues must
be carried out by
qualified electrician,
with reference to the
layouts attached at the
end of the manual.
CLEANING AND MAINTENANCE OPERATIONS:
8
of 2
9
GL50 MIXER
Summary of Contents for GL50
